1. The glass cutting is reasonably cut according to the size specifications of the user order, and the dimensional error is in accordance with the national standard. Women`S Pants`S Pants,Thin High Waist Pants,Loose Dark Women'S Jeans,Wide-Leg Overalls Shaoxing Ayura Clothing Co., Ltd , https://www.sxayura.com
2. The glass is cleaned and dried. The cut glass is polished with a coarse grinding wheel to prevent the hand from being scratched when the hand is moved and the stress is broken. Then it is cleaned and dried to ensure that the glass surface is free of oil and dust.
3. Printing product mark The name of the production unit and the product identification on the inner surface of the washed glass. The ink is made of white corrosion-resistant polyethylene quick-drying screen printing ink. After printing, it is cooled for 20 minutes and then enters the next process.
4, the glass splicing two pieces of glass are glued together, aligned around, fixed with a dovetail clip, and then 3-5 mm wide (thickness according to user needs) seals are placed around, the middle end of the upper end is filled with glue, Clip the clips and the number of clips is to ensure that the glue is not leaking. Or pad a small strip of glue at regular intervals around the perimeter and seal it with scotch tape.
5. Glue the glue to place the finished glass on the glue holder, adjust it to the angle of 30-45o, and then fill the glue. The amount of glue is calculated as follows:
V=L×B×d×1000 ml Note: V: glue weight (swell); L: glass length (m); B: glass width (m); d: seal strip thickness (mm), if it reaches national standard irrigation The amount of glue must be more than 800 ml per square meter.
After the adhesive is filled, check that the rubber layer is free of air bubbles, then place it horizontally and release the air seal.
6. Curing the potted glass to remove some of the clips, keep the quantity as little as possible without leaking the glue, and then place it horizontally into the violet light curing box or under the sunlight to cure (the clip can't block the filling surface). At the same time, there should be no obstructions on the upper surface of the glass.
7. Grinding edges are polished according to the contract requirements to ensure smooth and no protruding edges.
8. The glass produced by the inspection shall be inspected according to the standard of GB9962-1999 "Laminated Glass" or the requirements of the user contract. If there is any dispute or user's request, the product may be tested according to the national standard of the corresponding product.
9. Precautions (1) The glue has weak acidity. Try to avoid contact with iron containers and skin. Wear leather gloves when handling.
If it gets on your skin or eyes, rinse it off with soap and water.
(2) When the purple light is cured, the skin and eyes should be protected from exposure to light for a long time, and black protective glasses should be worn when entering the lamp room.
(3) When the sunlight is cured, since the adhesive layer has the function of blocking ultraviolet rays, it is not suitable for two or more layers to be simultaneously filled and cured.
(4) Due to the different materials and construction conditions, we recommend that you complete the necessary tests before use to ensure that our products are well applied.